Raisecom ISCOM2600G-HI (A) Series - Configuring Temperature Monitoring Alarm; Configuring Power Supply Alarm; Clearing All Hardware Environment Monitoring Alarms Manually

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
12 System management
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
528

When enabling global hardware environment monitoring alarm Syslog output,
alarm event can generate Syslog only when Syslog output under alarm event is
also enabled.

When enabling global hardware environment monitoring alarm sending Trap,
alarm event can send Trap only when Trap output under alarm event is also
enabled.
12.7.5 Configuring temperature monitoring alarm
Configure temperature monitoring alarm for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#
alarm temperature
{ notifies |
syslog }
Enable abnormal temperature alarm.
3
Raisecom(config)#
alarm temperature
{ high high - value
| low low - value |
notifies |
syslog }
Enable temperature monitoring alarm output and
configure temperature monitoring alarm output
modes.

The high temperature threshold (high-value) must
be greater than the low temperature threshold (low-
value).

The low temperature threshold (low-value) must be
smaller than the high temperature threshold (high-
value).
12.7.6 Configuring power supply alarm
Configure voltage monitoring alarm for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)# alarm
power-supply { notifies |
syslog }
Enable power supply alarm and
configure alarm output mode.
12.7.7 Clearing all hardware environment monitoring alarms
manually
Clear all hardware environment monitoring alarms manually for the ISCOM2600G-HI series
switch as below.