Raisecom ISCOM2600G-HI (A) Series User Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
10 Security
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
449
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#interface
interface-type interface-number
Enter physical layer interface
configuration mode.
3
Raisecom(config-
gigaethernet1/1/1)#pppoeagent
remote-id { client-mac | switch-
mac }
(Optional) configure PPPoE+
Remote ID to be padded with the
MAC address.
4
Raisecom(config-
gigaethernet1/1/1)#pppoeagent
remote-id format { ascii | binary }
(Optional) configure the padding
modes of the PPPoE+ Remote
ID.
Configuring Tag overriding
Tags of some fields may be forged by the client because of some reasons. The client overrides
the original Tags. After Tag overriding is enabled, if PPPoE packets contain Tags, these Tags
are overridden. If not, add Tags to these PPPoE packets.
Configure Tag overriding for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#interface
interface-type interface-number
Enter physical layer interface
configuration mode.
3
Raisecom(config-
gigaethernet1/1/1)#pppoeagent
vendor-specific-tag overwrite enable
Enable Tag overriding.
10.9.6 Checking configurations
Use the following commands to check configuration results.
No.
Command
Description
1
Raisecom#show pppoeagent
Show PPPoE+ configurations.
2
Raisecom#show pppoeagent statistic
Show PPPoE+ statistics.
10.9.7 Maintenance
Maintain the ISCOM2600G-HI series switch as below.

Raisecom ISCOM2600G-HI (A) Series Specifications

General

Brand	Raisecom
Model	ISCOM2600G-HI (A) Series
Category	Switch
Language	English