Raisecom ISCOM2600G-HI (A) Series - Page 181

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
2 Ethernet
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
150
SwitchB(config)#gvrp enable
Configure Switch C.
Raisecom#hostname SwitchC
SwitchC#config
SwitchC(config)#create vlan 5-10 active
SwitchC(config)#gvrp enable
Configure Switch D.
Raisecom#hostname SwitchD
SwitchD#config
SwitchD(config)#create vlan 15-20 active
SwitchD(config)#gvrp enable
Configure Switch E.
Raisecom#hostname SwitchE
SwitchE#config
SwitchE(config)#create vlan 25-30 active
SwitchE(config)#gvrp enable
Step 2 Configure GE 1/1/1, GE 1/1/2, and GE 1/1/3 on Switch A, GE 1/1/1, GE 1/1/2, and GE 1/1/3
on Switch B, GE 1/1/1 on Switch C, and GE 1/1/1 on Switch D to Trunk mode, and enable
GVRP on them. Take GE 1/1/1 on Switch A for example. Configurations of other interfaces
are the same.
SwitchA(config)#interface gigaethernet 1/1/1
SwitchA(config-gigaethernet1/1/1)#switchport mode trunk
SwitchA(config-gigaethernet1/1/1)#gvrp enable
SwitchA(config-gigaethernet1/1/1)#exit
Step 3 Configure GARP timers of GE 1/1/1, GE 1/1/2, and GE 1/1/3 on Switch A, GE 1/1/1, GE
1/1/2, and GE 1/1/3 on Switch B, GE 1/1/1 on Switch C, and GE 1/1/1 on Switch D, and
enable GVRP on them. Take GE 1/1/1 on Switch A for example. Configurations of other
interfaces are the same.
SwitchA(config)#interface gigaethernet 1/1/1
SwitchA(config-gigaethernet1/1/1)#garp timer leaveall 12000
SwitchA(config-gigaethernet1/1/1)#garp timer leave 3000
SwitchA(config-gigaethernet1/1/1)#garp timer join 600