Raisecom ISCOM2600G-HI (A) Series - Page 293

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
6 DHCP
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
262

Configure Switch A to connect it to the TFTP server.
Configuration steps
Establish a DHCPv6 server, configure the DHCPv6 address pool, and define Option 59 and
Option 60.
Step 1 Install the virtual machine program. For details, see virtual machine manuals.
Step 2 Configure the IPv4 address and IPv6 address of the virtual machine to 172.16.125.135/24 and
ffe:501:ffff:100::2 respectively.
Step 3 Install the DHCPv6 Server program on the virtual machine. For details, see its manuals.
Step 4 Configure the IPv4 address and IPv6 address of the DHCPv6 server.

Configure the IPv4 address and IPv6 address of the DHCPv6 server to
172.16.125.201/24 and 3ffe:501:ffff:100::5/64 respectively.

Configure the NIC of the virtual machine to be bridged with the NIC of the PC.
Step 5 Configure the DHCPv6 address pool and prefix length. Take a DHCPv6 Server program for
example.

Log in to the DHCPv6 Server console through its management address
"https://172.16.125.201".

Configure the DHCPv6 address pool to be 3ffe:501:ffff:100::105–3ffe:501:ffff:100::190
and prefix length to 64, as shown in Figure 6-7.
Step 6 Configure Option 59 and Option 60, as shown in Figure 6-7.

Configure the format of Option 59: option dhcp6.bootfile-url"3ffe:501:ffff:100::2"

Configure the format of Option 60: option dhcp6.bootfile-param"startup-
config:zeroconfig_startup_config,system-boot:ISCOM2600G-
HI_SYSTEM_3.11.142_20170315"