Raisecom ISCOM2600G-HI (A) Series User Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
1 Basic configurations
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
3

You can use the exit or quit command to return to the upper command mode.

You can execute the end command to return to privileged EXEC mode from any
modes but user EXEC mode and privileged EXEC mode.
The ISCOM2600G-HI series switch supports the following command line modes:
Mode
Enter method
Description
Privileged EXEC
In user EXEC mode, enter the enable
command and correct password.
Raisecom#
Global configuration
In privileged EXEC mode, enter the
config terminal command.
Raisecom(config)#
Physical layer
interface
configuration
In global configuration mode, enter the
interface { gigaethernet |
tengigabitethernet }
unit/slot/interface command.
Raisecom(config-
gigaethernet1/1/ in
terface )#
Raisecom(config-
tengigabitethernet
1/1/ interface )#
SNMP interface
configuration
In global configuration mode, enter the
interface fastethernet 1/0/1
command.
Raisecom(config-
fastethernet1/0/1)
#
Loopback interface
configuration
In global configuration mode, enter the
interface loopback lb-number
command.
Raisecom(config-
loopback)#
VLAN configuration
In global configuration mode, enter the
vlan vlan-id command.
Raisecom(config-
vlan)#
Aggregation group
configuration
In global configuration mode, enter the
interface port-channel channel-
number command.
Raisecom(config-
port-channel)#
Traffic classification
configuration
In global configuration mode, enter the
class-map class-map-name command.
Raisecom(config-
cmap)#
Traffic policy
configuration
In global configuration mode, enter the
policy-map policy-map-name
command.
Raisecom(config-
pmap)#
Traffic policy
configuration binding
with traffic
classification
In floe policy configuration mode,
enter the class-map class-map-name
command.
Raisecom(config-
pmap-c)#
Basic IP ACL
configuration
In global configuration mode, enter the
access-list acl-number command. In
this command, acl-number ranges from
1000 to 1999.
Raisecom(config-
acl-ipv4-std)#
Extended IP ACL
configuration
In global configuration mode, enter the
access-list acl-number command. In
this command, acl-number ranges from
2000 to 2999.
Raisecom(config-
acl-ipv4-ext)#

Raisecom ISCOM2600G-HI (A) Series Specifications

General

Brand	Raisecom
Model	ISCOM2600G-HI (A) Series
Category	Switch
Language	English