Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Configuration steps
Step 1 Create and configure the traffic class, and classify users by VLAN ID.
Raisecom#config
Raisecom(config)#class-map usera match-any
Raisecom(config-cmap)#match vlan 1
Raisecom(config-cmap)#quit
Raisecom(config)#class-map userb match-any
Raisecom(config-cmap)#match vlan 2
Raisecom(config-cmap)#quit
Raisecom(config)#class-map userc match-any
Raisecom(config-cmap)#match vlan 3
Raisecom(config-cmap)#quit
Step 2 Create rate limiting rules.
Raisecom(config)#mls qos policer-profile usera single
Raisecom(traffic-policer)#cir 25000 cbs 100
Raisecom(traffic-policer)#drop-color red
Raisecom(traffic-policer)##quit
Raisecom(config)#mls qos policer-profile userb single
Raisecom(traffic-policer)#cir 35000 cbs 100
Raisecom(traffic-policer)#drop-color red
Raisecom(traffic-policer)##quit
Raisecom(config)#mls qos policer-profile userc single
Raisecom(traffic-policer)#cir 30000 cbs 100
Raisecom(traffic-policer)#drop-color red
Raisecom(traffic-policer)##quit
Step 3 Create and configure the traffic policy.
Raisecom(config)#policy-map usera
Raisecom(config-pmap)#class-map usera
Raisecom(config-pmap-c)#police usera
Raisecom(config-pmap-c)#quit
Raisecom(config-pmap)#quit
Raisecom(config)#interface gigaethernet 1/1/1
Raisecom(config-gigaethernet1/1/1)#service-policy ingress usera
Raisecom(config-gigaethernet1/1/1)#exit
Raisecom(config)#policy-map userb
Raisecom(config-pmap)#class-map userb
Raisecom(config-pmap-c)#police userb
Raisecom(config-pmap-c)#quit
Raisecom(config-pmap)#quit
Raisecom(config)#interface gigaethernet 1/1/2
Raisecom(config-gigaethernet1/1/2)#service-policy ingress userb
Raisecom(config-gigaethernet1/1/1)#exit
Raisecom(config)#policy-map userc
To Next Page
Loading...
