Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Raisecom#config
Raisecom(config)#create vlan 10 active
Raisecom(config)#interface gigaethernet 1/1/2
Raisecom(config-gigaethernet1/1/2)#switchport mode trunk
Raisecom(config-gigaethernet1/1/2)#switchport trunk native vlan 10
Raisecom(config-gigaethernet1/1/2)#exit
Raisecom(config)#interface gigaethernet 1/1/3
Raisecom(config-gigaethernet1/1/3)#switchport access vlan 10
Raisecom(config-gigaethernet1/1/3)#exit
Raisecom(config)#interface gigaethernet 1/1/1
Raisecom(config-gigaethernet1/1/1)#switchport access vlan 10
Raisecom(config-gigaethernet1/1/1)#exit
Step 2 Enable IGMP Snooping.
Raisecom(config)#igmp snooping
Raisecom(config)#igmp snooping vlan 10
Step 3 Configure IGMP Querier.
Raisecom(config)#igmp querier
Raisecom(config)#igmp source-ip 192.168.1.2
Checking results
Use the following command to show configurations of IGMP Snooping.
Raisecom#show igmp snooping
IGMP snooping :Enable
IGMP report-suppression :Disable
IGMP version :v2
IGMP snooping active vlan :10
IGMP aging-time(s) :260
IGMP ring :--
Use the following command to show information about IGMP Snooping multicast group
members.
Raisecom#show igmp snooping member vlan 10
R- ring port D - Dynamic S - Static
Vlan Group Port Live-time(s) Flag
-------------------------------------------------------------------------
10 234.5.6.7 GE1/1/1 --
D
To Next Page
Loading...
Need help?
General
