Raisecom ISCOM2600G-HI (A) Series - Page 522

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
12 System management
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
491
Configuration steps
Step 1 Configure the IP address of the ISCOM2600G-HI series switch.
Raisecom#config
Raisecom(config)#interface vlan 1
Raisecom(config-vlan1)#ip address 20.0.0.10 255.255.255.0
Raisecom(config-vlan1)#exit
Step 2 Configure SNMPv1/SNMPv2c views.
Raisecom(config)#snmp-server view mib2 1.3.6.1.2.1 included
Step 3 Configure SNMPv1/SNMPv2c community.
Raisecom(config)#snmp-server community raisecom view mib2 ro
Step 4 Configure Trap sending.
Raisecom(config)#snmp-server enable traps
Raisecom(config)#snmp-server host 20.0.0.221 version 2c raisecom
Checking results
Use the show ip interface brief command to show configurations of the IP address.
Raisecom#show ip interface brief
VRF IF Address NetMask
Catagory
-------------------------------------------------------------------------
------------------------------
Default-IP-Routing-Table fastethernet1/0/1 192.168.0.1
255.255.255.0 primary
Default-IP-Routing-Table vlan1 20.0.0.10
255.255.255.0 primary
Use the show snmp view command to show view configurations.
Raisecom#show snmp view
Index: 0