EasyManuals Logo

ST STM32F412 User Manual

ST STM32F412
1163 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #620 background imageLoading...
Page #620 background image
Real-time clock (RTC) RM0402
620/1163 RM0402 Rev 6
22.3 RTC functional description
22.3.1 Clock and prescalers
The RTC clock source (RTCCLK) is selected through the clock controller among the LSE
clock, the LSI oscillator clock, and the HSE clock. For more information on the RTC clock
source configuration, refer to
Section 6: Reset and clock control (RCC) for STM32F412xx.
A programmable prescaler stage generates a 1 Hz clock which is used to update the
calendar. To minimize power consumption, the prescaler is split into 2 programmable
prescalers (see
Figure 207: RTC block diagram):
A 7-bit asynchronous prescaler configured through the PREDIV_A bits of the
RTC_PRER register.
A 15-bit synchronous prescaler configured through the PREDIV_S bits of the
RTC_PRER register.
Note: When both prescalers are used, it is recommended to configure the asynchronous prescaler
to a high value to minimize consumption.
The asynchronous prescaler division factor is set to 128, and the synchronous division
factor to 256, to obtain an internal clock frequency of 1
Hz (ck_spre) with an LSE frequency
of 32.768
kHz.
The minimum division factor is 1 and the maximum division factor is 2
22
.
This corresponds to a maximum input frequency of around 4 MHz.
f
ck_apre
is given by the following formula:
The ck_apre clock is used to clock the binary RTC_SSR subseconds downcounter. When it
reaches 0, RTC_SSR is reloaded with the content of PREDIV_S.
f
ck_spre
is given by the following formula:
The ck_spre clock can be used either to update the calendar or as timebase for the 16-bit
wakeup auto-reload timer. To obtain short timeout periods, the 16-bit wakeup auto-reload
timer can also run with the RTCCLK divided by the programmable 4-bit asynchronous
prescaler (see
Section 22.3.4 for details).
22.3.2 Real-time clock and calendar
The RTC calendar time and date registers are accessed through shadow registers which
are synchronized with PCLK1 (APB1 clock). They can also be accessed directly in order to
avoid waiting for the synchronization duration.
RTC_SSR for the subseconds
RTC_TR for the time
RTC_DR for the date
f
CK_APRE
f
RTCCLK
PREDIV_A 1+
---------------------------------------=
f
CK_SPRE
f
RTCCLK
PREDIV_S 1+()PREDIV_A 1+()×
----------------------------------------------------------------------------------------------=

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ST STM32F412 and is the answer not in the manual?

ST STM32F412 Specifications

General IconGeneral
BrandST
ModelSTM32F412
CategoryMicrocontrollers
LanguageEnglish

Related product manuals