ST STM32F412 User Manual

USB on-the-go full-speed (OTG_FS) RM0402
1006/1163 RM0402 Rev 6
29.15.6 OTG core interrupt register (OTG_GINTSTS)
Address offset: 0x014
Reset value: 0x0400 0020
This register interrupts the application for system-level events in the current mode (device
mode or host mode).
Some of the bits in this register are valid only in host mode, while others are valid in device
mode only. This register also indicates the current mode. To clear the interrupt status bits of
the rc_w1 type, the application must write 1 into the bit.
The FIFO status interrupts are read-only; once software reads from or writes to the FIFO
while servicing these interrupts, FIFO interrupt conditions are cleared automatically.
The application must clear the OTG_GINTSTS register at initialization before unmasking
the interrupt bit to avoid any interrupts generated prior to initialization.
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
WKUP
INT
SRQ
INT
DISC
INT
CIDS
CHG
LPM
INT
PTXFE HCINT
HPRT
INT
RST
DET
Res.
IPXFR/
IN
COMP
ISO
OUT
IISOI
XFR
OEP
INT
IEPINT Res. Res.
rc_w1 rc_w1 rc_w1 rc_w1 rc_w1 r r r rc_w1 rc_w1 rc_w1 r r
1514131211109876543210
EOPF
ISOO
DRP
ENUM
DNE
USB
RST
USB
SUSP
ESUSP Res. Res.
GO
NAK
EFF
GI
NAK
EFF
NPTXF
E
RXF
LVL
SOF
OTG
INT
MMIS CMOD
rc_w1 rc_w1 rc_w1 rc_w1 rc_w1 rc_w1 r r r r rc_w1 r rc_w1 r
Bit 31 WKUPINT: Resume/remote wakeup detected interrupt
Wakeup interrupt during suspend(L2) or LPM(L1) state.
– During suspend(L2):
In device mode, this interrupt is asserted when a resume is detected on the USB. In host
mode, this interrupt is asserted when a remote wakeup is detected on the USB.
– During LPM(L1):
This interrupt is asserted for either host initiated resume or device initiated remote wakeup
on USB.
Note: Accessible in both device and host modes.
Bit 30 SRQINT: Session request/new session detected interrupt
In host mode, this interrupt is asserted when a session request is detected from the device.
In device mode, this interrupt is asserted when V
BUS
is in the valid range for a B-peripheral
device. Accessible in both device and host modes.
Bit 29 DISCINT: Disconnect detected interrupt
Asserted when a device disconnect is detected.
Note: Only accessible in host mode.
Bit 28 CIDSCHG: Connector ID status change
The core sets this bit when there is a change in connector ID status.
Note: Accessible in both device and host modes.

ST STM32F412 Specifications

General

Brand	ST
Model	STM32F412
Category	Microcontrollers
Language	English