Fast-mode Plus Inter-integrated circuit (FMPI2C) interface RM0402
656/1163 RM0402 Rev 6
23 Fast-mode Plus Inter-integrated circuit (FMPI2C)
interface
23.1 Introduction
The I
2
C (inter-integrated circuit) bus interface handles communications between the
microcontroller and the serial I
2
C bus. It provides multimaster capability, and controls all I
2
C
bus-specific sequencing, protocol, arbitration and timing. It supports Standard-mode (Sm),
Fast-mode (Fm) and Fast-mode Plus (Fm+).
It is also SMBus (system management bus) and PMBus (power management bus)
compatible.
DMA can be used to reduce CPU overload.
23.2 FMPI2C main features
• I
2
C bus specification rev03 compatibility:
– Slave and master modes
– Multimaster capability
– Standard-mode (up to 100 kHz)
– Fast-mode (up to 400 kHz)
– Fast-mode Plus (up to 1 MHz)
– 7-bit and 10-bit addressing mode
– Multiple 7-bit slave addresses (2 addresses, 1 with configurable mask)
– All 7-bit addresses acknowledge mode
– General call
– Programmable setup and hold times
– Easy to use event management
– Optional clock stretching
– Software reset
• 1-byte buffer with DMA capability
• Programmable analog and digital noise filters
To Next Page
Loading...
