Remote Output setup 5 Connectivity settings
Set front/back offset
Configure the correct front/back offset.
1.
Accurately measure either of these as appropriate:
ll Autopilot systems: The distance between the fixed axle of the vehicle and the part of the
implement where the trigger marks will be applied on the ground.
l Manual guidance systems: The distance between the antenna center-point and the part of
the implement where the trigger marks will be applied on the ground.
2. At the Configuration screen, tap Implement Setup.
3. Enter the measurement as the F/B Offset distance on the Implement Boom Setup screen.
Calibrate front/back offset
1. Create a straight AB Line.
2. At the Remote Output screen, set the Lead Time to 0.
3. Drive as slowly as possible down the AB Line from point A to point B, marking points on the
ground where the remote output triggers.
4. At the end of the line, turn the vehicle around.
5. Drive back down the line from point B to point A, marking another set of trigger points.
6. Measure the distance between the points from the first run and the points from the second
run.
7. Divide the distance by two.
8. Adjust your Front/Back Offset value by this amount.
9. If the return points are nearer where you originally started than the first set of points, increase
the F/B offset.
10. If the return points are further from where you originally started than the first set of points,
lower the F/B offset.
Set lead time
1. Drive at your intended application speed down the AB Line from point A to point B, marking
points on the ground where the remote output triggers. Ensure that your speed remains
constant.
2. At the end of the line, turn the vehicle around.
3. Drive back down the line from point B to point A, marking the trigger points.
4. Measure any offset distance between the points from the first run and the points from the
second run.
134 FM-1000 Integrated Display User Guide Version 9.25, Revision B
To Next Page
Loading...