5 Connectivity settings Remote Output setup
5. Divide the distance by two.
6.
Convert your speed from mph to inches/second.
Inches/second = mph x 17.6.
7.
To calculate the lead time setting (in seconds), divide the distance between the points (in
inches) from Step 5 by the vehicle speed (in inches/second).
Lead Time = Half the distance between points (inches)divided by speed (inches per second)
8.
Enter the lead time at the Remote Output screen.
For example, if a 4mph pass creates a 14" distance between each set of points:
ll Divide the distance between the points by 2. (In this example, 14" / 2 = 7")
l Convert the speed from mph to inches/second. (4 mph = (4 x 17.6) = 70.4 inches/second)
l
Divide the halved distance between the points by the speeds
7" divided by 70.4" per second = 0.999 Lead time in seconds
9. Drive along the AB line and then back at your application speed while you create trigger points.
10. Ensure that the trigger points are sufficiently close to one another.
11. If the gap between the points is unacceptable, repeat the calibrations.
Version 9.25, Revision B FM-1000 Integrated Display User Guide 135
To Next Page
Loading...