8 Vehicle guidance setup Autopilot system
Setting Explanation
Operator Timeout
Coverage Log Manual or Engaged
6.
Tap the Steering tab and complete the appropriate settings.
Setting Explanation
Nudge Increment Distance the
Nudge
buttons on the Run screen move the line
back to the correct path
End of Row Warning Dist
Distance for the end-of-row warning to display
Note –
Longer vehicles that may take longer to turn require an earlier
warning, which dictates a greater distance.
AutoSense On or Off. Most recent Autopilot systems use an AutoSense
™
device that require this setting be set to On.
Valve On Speed
Under normal operating speeds this should be set to Normal.
For vehicles operating at very slow speeds, this should be set to
Low or Ultra Low. Speed thresholds for each option are:
ll Normal: > 0.4 m/s (1.3 ft/s)
l Low: >0.1 m/s (0.3 ft/s)
l Ultra Low: > 0.02 m/s (0.07 ft/s)
Note –
The Autopilot NavController II must have firmware version
5.10 or later to support the Low and Ultra Low settings.
Legacy Sensors
Only available if AutoSense is set to Off.
None, Wheel Speed Only, Gear Lever Only, or Wheel and Gear.
7.
Tap the Advanced tab. Tap OK. The Autopilot controller is now configured.
Note – For more information on how to use the Advanced tab, contact your local reseller.
Version 9.25, Revision B FM-1000 Integrated Display User Guide 187
To Next Page
Loading...