9 Field-IQ system setup Control setup
Setting Option Available with Valve
Types:
Explanation
locked in the position it was in when
the boom sections were closed.
PWM
Lock in Minimum
: The valve will lock into
a minimum position that is
configured in setup. With this option,
enter the
Minimum Preset Position
.
Servo
Fast Servo
Pump Servo
PWM
Hardi % Bypass
Lock in Standby Pressure: Used for
maintaining a minimum operational
pressure which enables a quicker
response when activating sections.
When sections are closed, this option
can be used.
If you choose this option, enter the
Standby Pressure later.
Auxiliary Valve All
Master: Valve closes when the system
is turned off.
Dump: Valve opens to dump flow-to-
return line when the system is turned
off.
Disable: Auxiliary valve not used or
disabled.
Pump Disarming
Switch
All
Enable: Select if you have a pump
disarming switch installed.
Disable: Select you do not have a
pump disarming switch installed.
Minimum Preset
Position
PWM Only available if you have chosen
PWMfor the valve type and
Lock in Last
Position
for
Valve Behavior on Sections Closed
.
Standby Pressure
Servo
Fast Servo
Pump Servo
PWM
Hardi % Bypass
Enter the psi. When you exit a
boundary, nonproductive exclusion
zone or previously covered area, the
system will hold the desired pressure.
When you enter a productive area
again that you want to spray, there
will be adequate pressure to keep a
good nozzle spray pattern.
Required if you selected Lock in Standby
for Valve Behavior on Sections Closed.
Version 9.25, Revision B FM-1000 Integrated Display User Guide 225
To Next Page
Loading...