Trimble FM-1000 - Page 410

GreenSeeker operation 18 Operations
ll The reference strip: Tap Ref, drive the reference strip and then tap Ref again to end
recording.
l The non-reference strip:Tap Non-Ref, drive the nonreference strip and then tap Non-Ref
again to end recording.
Note – As the NDVI is collected, the data displays. Keep the vehicle moving as you collect the data. If you
stop in one location, this will affect the average values. The Ref and Non-Ref buttons change to a lighter
color when selected or active.
6.
Tap Done. At the GreenSeeker Calibration screen on the Calibration panel, values that were
collected are displayed.
Setting Explanation
Maximum Reference: You can override the existing data and enter new
data.
Average
Non-Reference or Reference: You can override the existing
data and enter new data.
Minimum
Reference: You can override the existing data and enter new
data.
Calibrate
Non-Ref or Reference:Tap to collect fresh data.You will not
see the new values until you deselect the button you have
tapped.
Note – The reference values for Maximum , Average , and Minimum are also available for the Auto
Calibration function on the Algorithm tab.
7. When you are satisfied with the data on the Calibration tab, select the Algorithm tab.
8.
For Formula, select either:
ll An existing formula
l Custom Table to create a new algorithm (see Create a custom table (page 408))
Note – The formula selected for your last job will still be current, so you are often just verifying that the
correct formula is being used.
The values to be entered will change based upon the formula selected. Some values (such as
Nitrogen Use Efficiency) have default values that are formula specific. You can change any value by
tapping the entry box.
Note – You may need to reference the specific algorithms instruction for more detailed explanation of
the CumGDD F, or similar fields. For example the CumGDD F for the corn v1.3 GrtPlns GDD OKState is
Cumulative Growing Degree Days, Base 50F. For specific algorithm instructions, visit
www.GreenSeeker.com.
Tap OK.
9.
Go to the Chart tab and enter the settings.
410 FM-1000 Integrated Display User Guide Version 9.25, Revision B