18 Operations GreenSeeker operation
Setting Explanation
Limit
Enabled:
Disabled:
Max Limit If necessary, enter a value based on rate controller or
application equipment limitations.
Min Limit If necessary, enter a value based on rate controller or
application equipment limitations.
Note – Maximum and minimum settings will limit the rate commands given to the rate controller.
10. Review the application chart for each job to determine the appropriate nozzle selections
and/or application equipment settings.
11. Tap OK.
12.
Tap the Output tab.
13. From the Material Type list, select either Granular or Liquid.
14. Tap OK.
Version 9.25, Revision B FM-1000 Integrated Display User Guide 411
To Next Page
Loading...