18 Operations Water Management functionality
Control Explanation
ll Is not required to be an internal receiver
l Must be assigned to the appropriate guidance
plugin/feature
l Must be mounted in front of the antenna used for
WM-Drain
Pipe
Pipe Type:Select the type of pipe to be installed.
Pipe Size:The size of the pipe to be installed.
Recalc
When the tile plow encounters a rock, pull the boot up over
the rock and tap Recalc.
This modifies the design to ensure the remaining tile run
stays within the minimum slope requirement and prevents
the pipe from diving down to the original design grade.
Note –
This works only when installing tile in the direction away
from the outlet point.
Height Offset Increase button
Raise the tile boot or blade by the blade step increment.
Height Offset Decrease button
Lower the tile boot or blade by the blade step increment.
Height Offset
Coarse
or
Fine
button
When you tap Coarse, the increase or decrease button
moves the blade by the Coarse Blade increment. This
enables you to move the blade by a larger increment.
When you tap Fine, the increase or decrease button moves
the blade by the fine increment.
Pitch Offset Increase Raises the blade pitch relative to the design pitch.
Pitch Offset Decrease Lowers the blade pitch relative to the design pitch.
Coarse (Pitch Offset) When you tap Coarse, the increase or decrease button
moves the blade by the Coarse Pitch increment. This
enables you to move the blade pitch by a larger increment.
Point and slope mode
1.
At the Run screen, tap to open the WM-Drain panel.
2.
Go to the Install tab of the panel. Use the controls for installation or ditch cleaning.
Version 9.25, Revision B FM-1000 Integrated Display User Guide 467
To Next Page
Loading...