Yield Monitoring diagnostics 19 Diagnostics
Warning message Explanation
Current field is successfully recalibrated.
Unable to recalibrate current field. Calibration was unable to be applied to field,
possibly due to invalid data in field.
The calibration will be cleared. Are you sure you
want to do this?
User tapped Reset in a calibration screen.
The yield sensor calibration has been reset. User confirmed yield calibration reset.
The moisture sensor calibration has been reset. User confirmed moisture calibration reset.
The temperature sensor calibration has been
reset.
User confirmed temperature calibration reset.
No load information is available. You must
record some data by harvesting some crop
before you can run this calibration.
There are no loads for the current crop type.
This load is too small to be used for calibration
or contains invalid data.
The load data is not valid for calibration, usually
because the load is too small.
Optical sensor is not responding. Optical sensor failed to respond during tare
calibration.
No loads have been recorded. Use the 'New
Load' button on the map screen to record a
load.
Displayed in load details dialog if there are no
loads for the current crop type.
This load cannot be deleted because it is used
in the yield calibration.
Loads that were used for the current yield
calibration cannot be deleted.
This load cannot be deleted because it is used
in the moisture calibration.
Loads that were used for the current moisture
calibration cannot be deleted.
Loads cannot be recorded when there is no
field open.
Occurs when tapping New Load in the diagnostic
screen if no field is open.
You have chosen to delete some loads. Are you
sure you want to do this?
User tapped OK after selecting loads for deletion
in Load Details screen
The system is not yet ready to delete fields or
events.
The display needs some time to determine
whether deletion of the field/event would
remove a load that was used for calibration. Try
again later.
Accepting the new test weight will affect the
current calibration.
The average moisture will be reset to the Manual moisture will cause the average to be
512 FM-1000 Integrated Display User Guide Version 9.25, Revision B
To Next Page
Loading...