Yield Monitoring diagnostics 19 Diagnostics
Warning message Explanation
YIELD MONITOR: CAN bus error (state#XX). Unknown error when communicating with John
Deere yield monitor.
YIELD MONITOR: Failed to update crop type!!! Unable to set grain type in John Deere yield
monitor. Probable communication error.
YIELD MONITOR: Configuration Error
(state#XX). Verify the FmX is connected to the
CAN bus and CAN bus/combine series
configuration.
Lost connection with John Deere yield monitor.
YIELD MONITOR: Moisture sensor is not
connected
Trimble moisture sensor connection error.
YIELD MONITOR: Temperature sensor is
reporting values outside of a valid range
Bad reading received from temperature sensor.
YIELD MONITOR: Field changed on YM2000.
Verify that the Crop type is not inadvertently
changed on YM2000
YM2000 reported a "field" error.
YIELD MONITOR: Load changed on YM2000.
Verify that the crop type is not inadvertently
changed on YM2000.
YM2000 reported a "load" error.
YIELD MONITOR: Cannot Detect YM2000 Serial
Port (state#XX) !!!
Lost connection with YM2000 yield monitor.
514 FM-1000 Integrated Display User Guide Version 9.25, Revision B
To Next Page
Loading...