Basic system settings 3 Basic settings
Status Item Explanation
S Speed Speed of the vehicle as reported by the secondary blade GPS
receiver
S Target Height Height the secondary blade will attempt to reach. This is the Design
Height ± the Offset. When the blade reaches the Target Height, the
arrows turn green.
S Up Height of the secondary blade receiver relative to the field origin
point (a negative number means the blade is lower than the field
origin point)
S VDOP Vertical Dilution of Precision of the FieldLevel II GPS receiver: A
measure of accuracy based on the geometry of the satellites in the
sky. If the satellites are near each other in the sky, the VDOP is
higher (lower is better).
S Vertical Error Estimate Current estimate of error in the height calculated by the FieldLevel II
GPS receiver
Satellites Number of satellites the system is currently receiving
Secondary Pressure Current pressure, as reported by the secondary pressure sensor
Section Line Number Number of the current section line
Seed Mults % Percentage of time an more than one seed is placed for every
intended drop
Seed Population Amount of seed planted per acre/hectare
Seed Singulation Percentage of time an individual seed is placed for every intended
drop
Seed Skips % Percentage of seed that has not been planted
Seed Spacing Percentage of seed that has been applied in the specified spacing
Session Coverage Area Area that has been logged during the current session
Session Coverage Dist Distance covered while logging during the current session
Session Coverage Time Length of time that coverage logging has been engaged during the
current session
Session Time Length of the current field session
Short-term XTE Vehicle pass-to-pass Cross Track Error (XTE) when passes occur
within less than 15 minutes
Speed Current vehicle speed
80 FM-1000 Integrated Display User Guide Version 9.25, Revision B
To Next Page
Loading...