Delta ASDA-A2 User Manual

ASDA-A2 Chapter 5 Trial operation and Tuning
Revision February, 2017 5-5
6) When the screen displays:
Warning of over current:
Corrective Action:
 Check the connection between the motor and servo drive.
 Check if the conducting wire is short circuited.
Exclude short circuit and avoid metal conductors being exposed.
7) When the screen displays:
Warning of under voltage:
Corrective action:
 Check if the wiring of main circuit input voltage is correct.
 Use voltmeter to measure if the main circuit voltage is normal.
 Use voltmeter to measure if the power system complies with the specification.
NOTE
During the process of power on or servo on, if an alarm occurs or shows any abnormal display, please
contact the distributors.

Delta ASDA-A2 Specifications

General

Control Mode	Position, Speed, Torque
Model	ASDA-A2 Series
Operating Voltage	200 ~ 230VAC / 380 ~ 480VAC
Power Supply	200-230VAC ±10%, single-phase
Communication Interface	RS-485, CANopen
Feedback	Incremental encoder, Absolute encoder
Protection	Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit
Operating Temperature	0°C
Storage Temperature	-20°C
Humidity	20% to 90% RH (non-condensing)
Position Control Mode Features	Electronic Cam
Weight	Varies depending on the model. Please refer to the specific model's datasheet.