Delta ASDA-A2 User Manual

ASDA-A2 Chapter 8 Parameters
Revision February, 2017 8-33
P0-42 MAP8A Target Setting of Mapping Parameter P0-32
Address: 0054H
0055H
Operational
Interface：
Panel / Software Communication
Related Section:
4.3.5
Default：
0x0
Control
Mode：
ALL
Unit：
-
Range：
determined by the communication address of
the parameter group
Data Size：
32-bit
Format：
Hexadecimal
Settings：
P0-43 Reserved
P0-44★
PCMN Status Monitor Register (for PC software)
Address: 0058H
0059H
Operational
Interface：
Panel / Software Communication
Related Section:
4.3.5
Default：
0x0
Control
Mode：
ALL
Unit：
-
Range：
determined by the communication address of
the parameter group
Data Size：
32-bit
Format：
Decimal
Settings：
Same as parameter P0-09.

Delta ASDA-A2 Specifications

General

Control Mode	Position, Speed, Torque
Model	ASDA-A2 Series
Operating Voltage	200 ~ 230VAC / 380 ~ 480VAC
Power Supply	200-230VAC ±10%, single-phase
Communication Interface	RS-485, CANopen
Feedback	Incremental encoder, Absolute encoder
Protection	Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit
Operating Temperature	0°C
Storage Temperature	-20°C
Humidity	20% to 90% RH (non-condensing)
Position Control Mode Features	Electronic Cam
Weight	Varies depending on the model. Please refer to the specific model's datasheet.