Delta ASDA-A2 User Manual

Chapter 8 Parameters ASDA-A2
8-38 Revision February, 2017
to set the filter timing for the monitoring variable. The value of
monitoring variable will output after the filtering time determined by
parameter P0-53.
For example: when P0-09 is used
P0-54 ZON1L
General Range Compare Digital Output –
Lower Limit of 1st Monitoring Variable
Address: 006CH
006DH
Operational
Interface：
Panel / Software Communication
Related Section: N/A
Default：
0
Control
Mode：
ALL
Unit：
-
Range：
-2147483648 ~ +2147483647
Data Size：
32-bit
Format：
Decimal
Settings：The value of parameter P0-09 will change within the range between P0-
54 and P0-55 and then output after the filtering time determined by
parameter P0-53.
P0-55 ZON1H
General Range Compare Digital Output –
Upper Limit of 1st Monitoring Variable
Address: 006EH
006FH
Operational
Interface：
Panel / Software Communication
Related Section: N/A
Default：
0
Control
Mode：
ALL
Unit：
-
Range：
-2147483648 ~ +2147483647
Data Size：
32-bit

Delta ASDA-A2 Specifications

General

Control Mode	Position, Speed, Torque
Model	ASDA-A2 Series
Operating Voltage	200 ~ 230VAC / 380 ~ 480VAC
Power Supply	200-230VAC ±10%, single-phase
Communication Interface	RS-485, CANopen
Feedback	Incremental encoder, Absolute encoder
Protection	Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit
Operating Temperature	0°C
Storage Temperature	-20°C
Humidity	20% to 90% RH (non-condensing)
Position Control Mode Features	Electronic Cam
Weight	Varies depending on the model. Please refer to the specific model's datasheet.