Ford 2002 Bantam - Page 1391

417-01-67 Exterior Lighting 417-01-67
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
5 Measure the voltage between relay socket –
fog lamps, connector C320, pin 5, circuit 14-
LD9 (VT/BK) and ground.
• Is battery voltage indicated?
 Yes
GO TO S4
 No
REPAIR the open circuit(s) between fuse
F14 and relay – fog lamps, by using the wir-
ing diagrams. TEST the system for normal
operation.
S4: CHECK THE CONTROL CIRCUIT OF RELAY – FOG LAMPS
1 Turn the multifunction switch to the PARKING
LIGHT position.
2 Switch ON the front fog lamps.
3 Measure the voltage between relay socket –
fog lamps, connector C320, pin 1, circuit 29S-
LD8 (OG) and ground.
• Is battery voltage indicated?
 Yes
GO TO S5
 No
GO TO S7
S5: CHECK THE GROUND CONNECTION OF RELAY – FOG LAMPS
1.
2 Measure the resistance between relay socket –
fog lamps, connector C320, pin 2 and ground.
• Is the resistance less than 2 ohms?
 Yes
GO TO S6
 No
REPAIR the open circuit(s) between relay –
fog lamps and ground G6, by using the wir-
ing diagrams. TEST the system for normal
operation. If necessary INSTALL a new
CJB.
E9428 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL