501-16-7 Wipers and Washers 501-16-7
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
3.
Windshield wiper
motor C47
4.
5 Turn the multifunction switch to the SLOW
WIPER SPEED position.
6 Measure the voltage between windshield wiper
motor, connector C47, pin 4, circuit 14S-AK10
(VT/BK), harness side and ground.
• Is battery voltage indicated?
Yes
GO TO A7
No
CHECK the multifunction switch, according
to Component Testing attached to the wiring
diagrams. If necessary INSTALL a new one.
TEST the system for normal operation.
A7: CHECK THE GROUND CONNECTION OF WINDSHIELD WIPER MOTOR
1 Measure the resistance between windshield
wiper motor, connector C47, pin 1, circuit 31-
AK8 (BK), harness side and ground.
• Is the resistance less than 2 ohms?
Yes
CHECK the windshield wiper motor. If
necessary INSTALL a new one. TEST the
system for normal operation.
No
REPAIR the open circuit(s) between wind-
shield wiper motor and ground G10, by us-
ing the wiring diagrams. TEST the system
for normal operation.
A8: CHECK THE WINDSHIELD WIPER MOTOR FOR PROPER FUNCTION
1.
2.
Windshield wiper
motor C47
3.
4 Turn the multifunction switch to the FAST
WIPER SPEED position.
E9432 EN 07/2001 2002 Bantam
To Next Page
Loading...
