Ford 2002 Bantam - Page 1544

501-16-8 Wipers and Washers 501-16-8
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
5 Measure the voltage between windshield wiper
motor, connector C47, pin 5, circuit 14S-AK11
(VT/OG), harness side and ground.
• Is battery voltage indicated?
 Yes
CHECK the windshield wiper motor. If
necessary INSTALL a new one. TEST the
system for normal operation.
 No
GO TO A9
A9: CHECK THE MULTIFUNCTION SWITCH FOR PROPER FUNCTION
1. 2.
Windshield wiper
motor C47
3.
Multifunction
switch C15b
4.
5 Connect a jumper wire between multifunction
switch, connector C15b, pin 5, circuit 14S-
AK11 (VT/OG) and pin 7, circuit 14-AK19
(VT/OG), harness side.
• Does the windshield wiper motor operate
correctly (fast wiper speed)?
 Yes
CHECK the multifunction switch, according
to Component Testing attached to the wiring
diagrams. If necessary INSTALL a new one.
TEST the system for normal operation.
 No
REPAIR the open circuit(s) between multi-
function switch, connector C15b, pin 5 and
windshield wiper motor, by using the wiring
diagrams. TEST the system for normal op-
eration.
E9432 EN 07/2001 2002 Bantam