303-01B-108 Engine — 1.6L / 1.3L RoCam 303-01B-108
ASSEMBLY (CONTINUED)
E6645 EN 07/2001 2002 Bantam
16. Using the special tool, install the crankshaft
pulley.
1. Crankshaft pulley bolt
2. Special tool
3. Crankshaft pulley
4. New oil seal
17.
CAUTION: To prevent damage to the
oil seal, do not pull the crankshaft
pulley out more than 3 mm during
seal installation.
Tighten the crankshaft pulley bolt until the
oil seal is fully installed.
18. Remove the crankshaft pulley bolt.
19. Install the crankshaft pulley bolt.
20. NOTE:
Make sure that the O-ring seal is
correctly located.
Install the oil pump screen and pick up
tube.
To Next Page
Loading...
