303-01D-63 Engine — 1.8L Diesel - Endura DE 303-01D-63
IN-VEHICLE REPAIR (CONTINUED)
E5883 EN 09/2001 2002 Bantam
4. Put the camshaft bearing shell upper halves
in place and coat them with engine oil.
5. Apply sealer (SPM-4G-9112-F/G) to
bearing cap no. 1 in the areas indicated.
6. Install the camshaft.
NOTE: The bearing caps must lie flat.
• Locate camshaft bearing caps nos. 1, 3
and 5 in position.
NOTE: Tightening sequence.
• Screw on the nuts and tighten them.
7. Fit the oil baffle.
To Next Page
Loading...
