303-03-170 Engine — 1.8L Diesel - Endura DE 303-01D-170
09/2001 2002 Bantam
Endura - DE
Ring gap position The piston-ring gaps must be evenly
distributed on the circumference of the
piston. This also applies to the ele-
ments of the oil scraper ring. In each
case, offset the ring gaps by 120°_with
respect to each other.
Piston pins
Dimensions in mm
Piston pins 25,96 - 26,00
Piston pin type "Floating" in piston and connecting rod
Piston pin retention Snap-ring
Cylinder head
Dimensions in mm
Camshaft bearing Ø - standard 30,500 - 30,525
Camshaft bearing-Ø - oversize 30,575 - 30,600
Bore Ø - valve tappet - standard 35,000 - 35,030
Bore Ø - valve tappet - oversize 35,500 - 35,530
Bore Ø - valve stem guide - standard 8,000 - 8,025
Bore Ø - valve stem guide - 1st oversize 8,263 - 8,288
Bore Ø - valve stem guide - 2nd oversize 8,463 - 8,488
Thickness of cylinder head gasket Number of tooth marks
with piston protrusion of 0,500 - 0,680 mm 1,36 (2)
with piston protrusion of 0,681 - 0,740 mm 1,42 (3)
with piston protrusion of 0,741 - 0,840 mm 1,52 (4)
Max. permissible unevenness over entire cylinder head area 0,08 mm
Do not overhaul cylinder head mating face.
Camshaft
Valve timings, inlet valve opens BTDC 6°
Valve timings, inlet valve closes ABDC 32°
Valve timings, exhaust valve opens BBDC 57°
Valve timings, exhaust valve closes ATDC 7°
Cam lift (camshaft) - Inlet 9,0 mm
Cam lift - Exhaust 10,0 mm
End float 0,100 mm - 0,240 mm
Dimensions in mm
Bearing journal Ø 27,960 - 27,980
To Next Page
Loading...
