308-03-84 Manual Transaxle 308-03-84
DISASSEMBLY AND ASSEMBLY OF SUBASSEMBLIES (CONTINUED)
E1165 EN 07/2001
8. NOTE: Fit the shift ring with the annular
groove downwards and the smaller collar on
the hub upwards.
Fit the 3rd/4th gear synchronizer
1. Put on the synchronizer clutch, the
3rd/4th gear synchronizer assembly and
the 3rd gearwheel.
2. Fit the snap-ring.
9. NOTE: Fit the ball bearing with the annular
groove towards the outside.
Fit the 4th gearwheel and the ball bearing.
1. Put on the 4th gear synchronizer ring
and the 4th gearwheel.
2. Press on the ball bearing using the
workshop press.
• Fit the snap-ring.
To Next Page
Loading...
