MPC5604B/C Microcontroller Reference Manual, Rev. 8
148 Freescale Semiconductor
This register allows a way to disable the device modes which are not required for a given device. RESET,
SAFE, DRUN, and RUN0 modes are always enabled.
Table 8-6. Mode Enable Register (ME_ME) Field Descriptions
Field Description
STANDBY STANDBY mode enable
0 STANDBY mode is disabled
1 STANDBY mode is enabled
STOP STOP mode enable
0 STOP mode is disabled
1 STOP mode is enabled
HALT HALT mode enable
0 HALT mode is disabled
1 HALT mode is enabled
RUN3 RUN3 mode enable
0 RUN3 mode is disabled
1 RUN3 mode is enabled
RUN2 RUN2 mode enable
0 RUN2 mode is disabled
1 RUN2 mode is enabled
RUN1 RUN1 mode enable
0 RUN1 mode is disabled
1 RUN1 mode is enabled
RUN0 RUN0 mode enable
0 RUN0 mode is disabled
1 RUN0 mode is enabled
DRUN DRUN mode enable
0 DRUN mode is disabled
1 DRUN mode is enabled
SAFE SAFE mode enable
0 SAFE mode is disabled
1 SAFE mode is enabled
TEST TEST mode enable
0 TEST mode is disabled
1 TEST mode is enabled
RESET RESET mode enable
0 RESET mode is disabled
1 RESET mode is enabled
To Next Page
Loading...
