Hirschmann RS20

Content
CLI L2P
Release 7.0 05/2011
5
4.5.1 link-aggregation staticcapability 93
4.5.2 show link-aggregation brief 94
4.6 Management Commands 95
4.6.1 telnet 95
4.6.2 transport input telnet 96
4.6.3 transport output telnet 97
4.6.4 session-limit 98
4.6.5 session-timeout 99
4.6.6 bridge address-learning 99
4.6.7 bridge address-relearn detect operation 100
4.6.8 bridge address-relearn detect threshold 100
4.6.9 bridge aging-time 101
4.6.10bridge fast-link-detection 102
4.6.11bridge duplex-mismatch-detect operation 102
4.6.12bridge vlan-learning 103
4.6.13digital-input 103
4.6.14digital-output 105
4.6.15show digital-input 108
4.6.16show digital-input config 109
4.6.17show digital-input all 110
4.6.18show digital-input <slot/input> 111
4.6.19show digital-output 112
4.6.20show digital-output config 113
4.6.21show digital-output all 114
4.6.22show digital-output <slot/output> 115
4.6.23ethernet-ip 116
4.6.24network javascriptmode 116
4.6.25network mgmt-access add 118
4.6.26network mgmt-access delete 118
4.6.27network mgmt-access modify 119
4.6.28network mgmt-access operation 120
4.6.29network mgmt-access status 120
4.6.30network parms 121
4.6.31network protocol 121
4.6.32network priority 122
4.6.33profinetio 123
4.6.34serial timeout 124
4.6.35set prompt 125
4.6.36show ethernet-ip 125
4.6.37show network 126