WindO/I-NV4 User’s Manual 13-35
4 Using Data and Detected Alarms
13
Alarm Log Function
10
Repeat steps 3 through 9 to register messages for all the channels.
11
Click OK.
The Alarm Log Settings dialog box closes.
12
On the Home tab, in the Parts group, click Data Displays, and then click Alarm List Display.
13
Click a point on the edit screen where you wish to place the Alarm List Display.
14
Double-click the placed Alarm List Display and a Properties dialog box will be displayed.
15
On the General tab, under Message Settings, select Use Alarm Log Settings.
16
Configure the other settings and the settings on each tab as necessary.
For details, refer to Chapter 10 “7.3 Properties of Alarm List Display Dialog Box” on page 10-138.
17
Click OK.
The Properties of Alarm List Display dialog box closes.
This concludes configuring the MICRO/I to display registered messages with the Alarm List Display according to the
active alarm.
The messages to use can be registered in advance in Text Manager.
To Next Page
Loading...
General