1 Numerical Input
10-2 WindO/I-NV4 User’s Manual
1.2 Numerical Input Configuration Procedure
This section describes the configuration procedure for Numerical Inputs.
1 On the Home tab, in the Parts group, click Data Displays, and then click Numerical Input.
2 Click a point on the edit screen where you wish to place the Numerical Input.
3 Double-click the placed Numerical Input and a Properties dialog box will be displayed.
4 Change the settings on each tab as necessary.
The Data Over tab, Trigger Condition tab and Options tab only appear in Advanced mode.
You can set the default for the Numerical Input on the Default Preferences tab of the WindO/I-NV4
Options dialog box. For details, refer to Chapter 2 “Default Preferences Tab” on page 2-63.
To Next Page
Loading...
General