WindO/I-NV4 User’s Manual 29-3
1 Project Transfer Function
29
Data Transfer Function
1.3 Converting Project for Transfer
Project must be converted to dedicated data for transfer in order to download project to the MICRO/I using the
project transfer function.
Use the following procedure to create project data for transfer using an external memory device
*1
.
1 Insert an external memory device
*1
in the computer.
Insert an external memory device
*1
into the USB port or memory card slot of your computer, or via a docking station,
etc.
2 Open the project to transfer using WindO/I-NV4.
3 On the Home tab, in the Project group, click the Download icon.
The Download dialog box is displayed.
*1 Only USB flash drive for HG2J-7U, HG2G-5T and HG1G/1P
The Project Transfer function supports the project which name is used alphanumeric characters only.
Computer
Via a docking station etc.
SD memory card
Into SD memory card slot
Into USB port
USB flash drive
SD memory card
USB flash drive
To use the Project Transfer function, select the project which name is used alphanumeric characters only.
When the project has not been saved after it was opened, a save confirmation message is displayed.
Click the OK button to save the project and display the Download dialog box.
Click on the Cancel button to return to the editing screen without saving the project.
To Next Page
Loading...
General