7 Timer
12-62 WindO/I-NV4 User’s Manual
7.3 Properties of Timer Dialog Box
This section describes items and buttons in the Properties dialog box.
●
General Tab
■ Part Name
Enter a name for the part. The maximum number is 20 characters.
■ Timer Address Number
Specifies the HMI timer address number (0 to 31).
The device type for the HMI timer relay is LTC. The device type where the current value is stored is LTD.
■ Unit
Select the unit of time from sec or 100 msec.
■ Preset Value
Select the data type to use and the enter the preset value.
The preset value is the time from when the timer starts its countdown until 1 is written to the HMI Timer Relay LTC.
Example: When 0 is specified for Timer Address Number
HMI Timer Relay: LTC0
HMI Timer Current Value: LTD0
Value: When selecting sec in Unit, the preset value is specified with 1 to 65535 (second units) up to a
maximum of 1092 minutes 15 seconds.
When selecting 100 msec in Unit, the preset value is specified with 1 to 65535 (100 msec units).
Device Address: Uses a value of device address.
Specify the device address.
Click to display the Tag Editor. For the device address configuration procedure, refer to Chapter
2 “5.1 Device Address Settings” on page 2-70.
To Next Page
Loading...
General