WindO/I-NV4 User’s Manual 28-67
5 Social Media Function
28
Maintenance
5.6 Social Media Function Configuration Procedure
This section describes the configuration procedure for the Twitter account and the social media message.
1 On the Configuration tab, in the System Setup group, click Social Media.
The Social Media Settings dialog box is displayed.
2 Select the number to use the Social media function in (Settings).
The settings for the selected number are displayed in to the right of the list.
3 Select the condition to send a social media message in Trigger Type under Trigger Condition from the following.
■ Rising-edge
A social media message is sent when the value of device address changes from 0 to 1.
Specify the bit device or the bit number of the word device as the condition.
Click to display the Tag Editor. For the device address configuration procedure, refer to Chapter 2 “5.1 Device
Address Settings” on page 2-70.
■ Falling-edge
A social media message is sent when the value of device address changes from 1 to 0.
Specify the bit device or the bit number of the word device as the condition.
Click to display the Tag Editor. For the device address configuration procedure, refer to Chapter 2 “5.1 Device
Address Settings” on page 2-70.
■ Satisfy the condition
A social media message is sent when the condition changes from not satisfied to satisfied.
Specify the conditional expression in Condition and select the data type handled by the conditional expression in
Data Type.
Click to display the Trigger Condition Settings dialog box. For the conditional expressions configuration
procedure, refer to Chapter 2 “5.2 Setting Conditional Expressions” on page 2-73.
For details on data types, refer to Chapter 2 “1.1 Available Data” on page 2-1.
4 Click Account under the Social Media content.
The Social Media Account Manager is displayed.
(Settings)
(Message)