IDEC WindO/I-NV4 - Flow from Screen Creation and to Run Operation

WindO/I-NV4 User’s Manual 1-5
4 Flow from Screen Creation and to Run Operation
1
System Composition
The following flowchart describes the sequence of step from the screen creation for the MICRO/I to the Run
operation.
4 Flow from Screen Creation and to Run Operation
1
Launch the WindO/I-NV4
2
Creating a Project and Screen
Modifying the project
6
Troubleshooting
8
Maintenance
4
Downloading the project
3
Saving the project
5
Debug
7
RUN
( refer to Chapter 2 “2.1 Starting WindO/I-NV4” on page 2-38)
Creating a new project ( refer to Chapter 4 “1.1 Creating New Project Data” on page 4-1)

• Creating new screens ( refer to Chapter 5 “2.1 Creating Screens” on page 5-2)
( refer to Chapter 24 “2 Downloading” on
page 24-12)
(refer to Chapter 25 “Monitor Function” on
page 25-1)
( refer to Chapter 36 “Troubleshooting” on
page 36-1)
(refer to Chapter 28 “Maintenance” on page
28-1)
( refer to Chapter 4 “1.3 Saving Project
Data” on page 4-5)
(refer to Chapter 26 “Simulator Function”
on page 26-1)