IDEC WindO/I-NV4 User Manual

WindO/I-NV4 User’s Manual 25-1
25
Monitor Function
This chapter describes the monitor function that checks operation of the created project data.
Monitor function enables the values of internal devices and the values of the external device addresses to be checked
and changed. This can be done in two ways: using WindO/I-NV4 on a computer connected to the MICRO/I, or directly
on the screen of the MICRO/I.
1.1 How the Monitor Function in WindO/I-NV4 is Used
Monitor function in WindO/I-NV4 can be performed as follows.
• Checking values of device addresses used on the screen of the MICRO/I
• Checking values of specified device addresses
• Checking values of device addresses of sequential address numbers
Chapter 25 Monitor Function
1 Monitoring with WindO/I-NV4
HG3G HG2G-5FHG5G-V HG4G-V HG3G-V HG2G-V HG2G-5T HG4G HG1G HG1P HG2J-7U
Computer
MICRO/I
130
External device
Screen Monitor
LDR1
LM0
Displays device addresses used in a screen.
LDR1
LM0
Computer
MICRO/I
130
External device
Custom Monitor
Select device address
Computer
MICRO/I
130
External device
Batch Monitor
Sequential address numbers
LM0
LM1
LM2
Length: 3
(Starting address number)

IDEC WindO/I-NV4 Specifications

General

Brand	IDEC
Model	WindO/I-NV4
Category	Organizer
Language	English