3 Project Settings Dialog Box
4-70 WindO/I-NV4 User’s Manual
3.14 E-mail Tab
You can set the outgoing mail server (SMTP) to be used for sending an e-mail from MICRO/I. For details, refer to
Chapter 28 “4 E-mail Function” on page 28-38.
■ General Setting
HG3G
HG2G-5FHG5G-V HG4G-V HG3G-V HG2G-V HG2G-5T
HG4G HG1G HG1P
HG2J-7U
Outgoing mail server (SMTP): Selects the Outgoing mail server (SMTP) setting method.
Host Name: Specifies the Host Name of the outgoing mail server (SMTP).
The maximum number is 40 characters. Only alphanumeric characters,
-(dash) and .(period) can be used.
IP Address: Specifies the IP address of the outgoing mail server (SMTP).
The format is “xxx.xxx.xxx.xxx”. “xxx” stands for a numeric value from
0 to 255.
If Host Name is selected, the IP address of the outgoing mail server (SMTP) is looked up and obtained from
the host name using the DNS server. In order to access a DNS server from the MICRO/I, the IP address of
the DNS server must be specified. For details, refer to “ When Ethernet is selected under Interface
Configuration” on page 4-41.
Outgoing mail server (SMTP) port number: Specifies the port number for the outgoing mail server (SMTP) (0 to
65535).
The outgoing mail server (SMTP) port number to use varies based on the server. For details, contact the
administrator of the network which the MICRO/I is connected to.
Normally, port number 25 for SMTP, and port number 587 for SMTP-AUTH are used.
To Next Page
Loading...
General