2 Line Chart
11-22 WindO/I-NV4 User’s Manual
2.2 Line Chart Configuration Procedure
This section describes the configuration procedure for Line Charts.
1 On the Home tab, in the Parts group, click Charts, and then click Line Chart.
2 Click a point on the edit screen where you wish to place the Line Chart.
3 Double-click the placed Line Chart and a Properties dialog box will be displayed.
4 Change the settings on each tab as necessary.
You can set the default for the Line Chart on the Default Preferences tab of the WindO/I-NV4 Options
dialog box. For details, refer to Chapter 2 “Default Preferences Tab” on page 2-63.