IDEC WindO/I-NV4 - Bit Write Command Configuration Procedure

WindO/I-NV4 User’s Manual 12-3
1 Bit Write Command
12
Commands
1.2 Bit Write Command Configuration Procedure
This section describes the configuration procedure for the Bit Write Command.
1 On the Home tab, in the Parts group, click Commands, and then click Bit Write Command.
2 Click a point on the edit screen where you wish to place the Bit Write Command.
3 Double-click the placed Bit Write Command and a Properties dialog box will be displayed.
4 Change the settings on each tab as necessary.