11 Calendar
10-206 WindO/I-NV4 User’s Manual
11.2 Calendar Configuration Procedure
This section describes the configuration procedure for Calendars.
1 On the Home tab, in the Parts group, click Data Displays, and then click Calendar.
2 Click a point on the edit screen where you wish to place the Calendar.
3 Double-click the placed Calendar and a Properties dialog box will be displayed.
4 Change the settings on each tab as necessary.
The Trigger Condition tab and Options tab only appear in Advanced mode.
You can set the default for the Calendar on the Default Preferences tab of the WindO/I-NV4 Options
dialog box. For details, refer to Chapter 2 “Default Preferences Tab” on page 2-63.
To Next Page
Loading...
General