IDEC WindO/I-NV4 - Goto Screen Command Configuration Procedure

WindO/I-NV4 User’s Manual 12-19
3 Goto Screen Command
12
Commands
3.2 Goto Screen Command Configuration Procedure
This section describes the configuration procedure for the Goto Screen Command.
1 On the Home tab, in the Parts group, click Commands, and then click Goto Screen Command.
2 Click a point on the edit screen where you wish to place the Goto Screen Command.
3 Double-click the placed Goto Screen Command and a Properties dialog box will be displayed.
4 Change the settings on each tab as necessary.