WindO/I-NV4 User’s Manual 4-81
3 Project Settings Dialog Box
4
Project Settings
3.19 Internal Clock Tab
Configure the SNTP server, time zone, and daylight saving time to get date and time data. The acquired date and time
data is written to the internal clock of MICRO/I.
■ SNTP Server
Selects the SNTP server setting method.
HG3G
HG2G-5FHG5G-V HG4G-V HG3G-V HG2G-V HG2G-5T
HG4G HG1G HG1P
HG2J-7U
Host Name: Specifies the host name of the SNTP server.
The maximum number is 40 characters. Only alphanumeric characters, -(dash) and .(period)
can be used.
IP Address: Specifies the IP address of the SNTP server.
The format is "xxx.xxx.xxx.xxx". "xxx" stands for a numeric value from 0 to 255.
• If Host Name is selected, the IP address of the SNTP server is looked up and obtained from the host
name using the DNS server. In order to access a DNS server from the MICRO/I, the IP address of the DNS
server must be specified. For details, refer to “ When Ethernet is selected under Interface Configuration”
on page 4-41.
• The port number is 123.
Obtain the date and time automatically with the following condition or operation:
Set the conditions for acquiring date and time data from the SNTP server.
Fixed Time: Select this check box to get date and time data from the SNTP server on a regular basis,
and then select the period to get the data from the following.
Every 10 Minutes, Every 1 Hour, Every 1 Day, Every 1 Week, Every 30 Days
Turn on the power: Select this check box to get the date and time data from the SNTP server when the MICRO/
I power is turned on.
To Next Page
Loading...
General