4 E-mail Function
28-42 WindO/I-NV4 User’s Manual
4.8 E-mail Function Configuration Procedure
This section describes the configuration procedure for the outgoing mail server (SMTP) and the e-mail.
●
Outgoing Mail Server (SMTP) Settings
1 On the Configuration tab, in the System Setup group, click Project.
The Project Settings dialog box is displayed.
2 Configure the items on the E-mail tab.
■ General Setting
Outgoing mail server (SMTP): Selects the Outgoing mail server (SMTP) setting method.
Host Name: Specifies the Host Name of the outgoing mail server
(SMTP).
The maximum number is 40 characters. Only
alphanumeric characters and symbols can be used.
IP Address: Specifies the IP address of the outgoing mail server
(SMTP).
The format is “xxx.xxx.xxx.xxx”. “xxx” stands for a
numeric value from 0 to 255.
Outgoing mail server (SMTP) port number: Specifies the port number for the outgoing mail server (SMTP) (0 to
65535).
Sender E-mail Address: Enter an e-mail address of the sender. The maximum number is 40
characters. Only alphanumeric characters and symbols can be used.
Sender Name: Enter a name of the sender. The maximum number is 40 characters.
Only alphanumeric characters and symbols can be used.
Use secure connection (SSL/TLS): Select this check box to use SSL/TLS communications with the outgoing
mail server.
To Next Page
Loading...
General