EasyManuals Logo

IDEC WindO/I-NV4 User Manual

IDEC WindO/I-NV4
1738 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1417 background imageLoading...
Page #1417 background image
WindO/I-NV4 User’s Manual 28-21
3 FTP Client Function
28
Maintenance
3.3 Supported Commands and Transfer modes
Commands defined by RFC959
Active mode and Passive mode
3.4 Verified FTP Server
With the FTP client function, the operation has been checked by using the following FTP server.
*1
Microsoft Internet Information Services
FileZilla
Very Secure FTP Daemon
MICRO/I (FTP server function)
IDEC PLC (FTP server function)
3.5 FTP Client Function Configuration Procedure
This section describes the configuration procedure for the FTP server and the FTP client function.
Configure the FTP Server
Configures the target FTP server.
1 On the Configuration tab, in the Manager group, click FTP Server Manager.
The FTP Server Manager is displayed.
2 Select the number to configure the FTP server in (FTP Server List), then click Edit.
The Individual Settings dialog box for the selected number is displayed.
*1 HG2J-7U as of December 2021, HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F/-5T, HG1G/1P type as of May 2018
SFTP and FTPS are not supported.
To use FileZilla, select the Limit number of simultaneous connections check box on Transfer
Settings tab in Site Manager and set Maximum number of connections to "1" in advance.
FTP Server List

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IDEC WindO/I-NV4 and is the answer not in the manual?

IDEC WindO/I-NV4 Specifications

General IconGeneral
BrandIDEC
ModelWindO/I-NV4
CategoryOrganizer
LanguageEnglish