3 Preventive Maintenance Settings Dialog Box
17-10 WindO/I-NV4 User’s Manual
■ Data Type
Select the data type for the operation count device address as UBIN16(W) or UBIN32(D). For details, refer to
Chapter 2 “1.1 Available Data” on page 2-1.
■ Report when Operation Count has reached or exceeded Threshold level
Select this check box to report when the counted operation count reaches or exceeds the threshold.
■ (Data Type)
Selects the type of data for the threshold.
■ Level 1
Configures the level 1 threshold and Report Device Address.
■ Level 2
Select this check box to configure the level 2 threshold and Report Device Address.
■ Level 3
Select this check box to configure the level 3 threshold and Report Device Address.
Value: Uses a constant as the threshold.
Device Address: Uses a value of device address as the threshold.
Threshold Specifies the count as a constant or a device address that is the criterion for reporting at
level 1. For a constant, the range that can be set varies based on the data type. For a device
address, click to display the Tag Editor. For the device address configuration procedure,
refer to Chapter 2 “5.1 Device Address Settings” on page 2-70.
Report Device Address: Specifies the bit device or the bit number of the word device for reporting when the
operation count reaches or exceeds the level 1 threshold.
Click to display the Tag Editor. For the device address configuration procedure, refer to
Chapter 2 “5.1 Device Address Settings” on page 2-70.
Threshold Specifies the count as a constant or a device address that is the criterion for reporting at
level 2. For a constant, the range that can be set varies based on the data type. For a device
address, click to display the Tag Editor. For the device address configuration procedure,
refer to Chapter 2 “5.1 Device Address Settings” on page 2-70.
Report Device Address: Specifies the bit device or the bit number of the word device for reporting when the
operation count reaches or exceeds the level 2 threshold.
Click to display the Tag Editor. For the device address configuration procedure, refer to
Chapter 2 “5.1 Device Address Settings” on page 2-70.
Threshold Specifies the count as a constant or a device address that is the criterion for reporting at
level 3. For a constant, the range that can be set varies based on the data type. For a device
address, click to display the Tag Editor. For the device address configuration procedure,
refer to Chapter 2 “5.1 Device Address Settings” on page 2-70.
Report Device Address: Specifies the bit device or the bit number of the word device for reporting when the
operation count reaches or exceeds the level 3 threshold.
Click to display the Tag Editor. For the device address configuration procedure, refer to
Chapter 2 “5.1 Device Address Settings” on page 2-70.
To Next Page
Loading...
General