2 Security Function Configuration Procedure
23-12 WindO/I-NV4 User’s Manual
4 Specify the user number (1 to 15) in Number
This number is used when switching the user account via the value of device address.
5 Enter the name for the new user in User Name.
The maximum number for the user name is 16 characters. Only alphanumeric characters and symbols can be used.
6 Enter the password in New Password.
The number for the password is 4 to 15. Only alphanumeric characters and symbols can be used.
7 Enter the password in Confirm Password that was entered in step 6.
8 Click the Group Membership tab.
Assign the security groups to the user being created.
Administrator, Operator, and Reader have already been provided in Security Group.
If you will not add a new security group, proceed to step
17
.
If you will not assign a security group, proceed to step
18
.
• You cannot use the following characters in the user name.
" * . / : < > ? \ |
• For the HG2J-7U, do not set # at the beginning of the user name. User names start with # will prevent
access to the MICRO/I FTP server.
Write down the password so you do not forget it and save that note in a safe place.
To display the content of the password for New Password and Confirm Password, select the Show
Passwords check box in the Security dialog box.
User3User2User1
Administrator AdministratorOperator
Operator
Reader
To Next Page
Loading...
General